Fine Art Floral DSP with Fluttering Dies - Fancy Fold

Fine Art Floral with Happy Thoughts

Fancy Fold

 

YOUTUBE VIDEO LINK

 

Fine Art Floral with Happy Thoughts

Fancy Fold

Supplies:

Stamp Sets – Happy Thoughts [154507]

Card Stock – Smoky Slate [131202], Fine Art Floral DSP [154558], Basic White [159276],

                           Calypso Coral [122925] - butterfly die, Basic Black [121045] - butterfly die, 

                           Pool Party [122924] - 2 inch circle punch

Stamp Pads – Memento Black Ink [132708]

Misc - Fluttering Dies [154318], Stampin’ Cut & Emboss Machine [149653], 

             2" Circle Punch [133782], 2 ¼" Circle Punch [14372], 

             Mini Dimensionals [144108], Stampin’ Seal [152813], Dimensionals [104430]

 

Measurements:

  • Card Base 4 ¼" x 9 ½" scored at 3" and 7 ¼"
  • Inside Liner 4" x 4"
  • Patterned Paper 2 ¾" x 4"
  • 2” Circle Punch SCRAP - coordinating color
  • 2 ¼” Circle Punch SCRAP - match card base color
  • Butterfly Die SCRAP - coordinating color
  • Butterfly Die SCRAP - coordinating color
  • Sentiment Label 1 ½” x 3 ¼” 

 

Instructions:

  1. With the card base open, and the narrowest scored section on the right, slide the 2 ¼" circle punch all the way in from the top of the card, lining up the score line on the right in the center of the circle. Then punch out the circle.
  2. Adhere the 4" x 4" square inside the card – make sure to not place any adhesive on the portion that overlaps the circle opening (or you will have adhesive on the back of your card).
  3. Punch a 2 ¼" circle from Smoky Slate cardstock (same as your card base color).
  4. Close the card and then adhere the 2 ¼" punched circle in the “half” circle that exposes the liner panel. I added my adhesive to the white liner and then placed the circle down. 
  5. Punch a 2" circle from Pool Party cardstock, layer it on the 2 ¼" circle.
  6. Using the Fluttering dies, die cut the embossed butterfly from Calypso Coral, and the solid butterfly from Basic Black.  Adhere the butterflies together. Then add to the center of your circles.
  7. Close the card and adhere the Designer Paper to the left panel.
  8. With the label die from the Fluttering Dies, and with a 1 ½” x 3 ¼” piece of Smoky Slate, create the sentiment label.  
  9. Die-cut once lining up the die with the top and side of the cardstock. [It’s okay that the die is larger than the cardstock.]  
  10. Then die-cut again, so that you have all four corners matching.
  11. Stamp the greeting in Black ink.  Add to the card.
  12. Stamp our inside greeting.